Tech-source Raptor Drivers for Linux Bedienungsanleitung PDF herunterladen (Seite 27)

Chapter 4 – Software Installation for T-Class Cards

4-5

4.6 Configuring XFree86 Server for PC

Graphics Hardware

This section assumes that the XF86Config file was configured

to work properly with your existing VGA/SVGA cards. For

documentation on how to install and configure your VGA/SVGA

card, please refer to the XFree86 documentation.

After installing the Raptor drivers, three sections will be added to

the /etc/X11/XF86Config-4 file for each of the cards,

provided that the file exists in the system. Otherwise,

/etc/X11/XF86Config will be used. If you are using another

config file, the three sections can be imported from:

/etc/X11/XF86Config.rap2kt or

/etc/X11/XF86Config.rap1kt or

/etc/X11/XF86Config.raptfp or

/etc/X11/XF86Config.rapifp

The sections for a Raptor 2100T are listed below. The Device

and Screen sections for the other cards are similar. The

required modifications are explained in the following

subsections.

# TSI Raptor 2100T XFree86 Configuration Sections

Section "Monitor"

Identifier "Sony DDM Rap2kt"

VendorName "Sony"

ModelName "DDM-2800"

HorizSync 31.5 - 150.0

VertRefresh 50-90

ModeLine "2048x2048" 357.18 2048 2088 2408

2816 2048 2051 2054 2114

DisplaySize 498 498

EndSection

NOTE: From this point on, the name XF86Config will be

used to refer to the config file used by the XFree86 server.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 63 64

Keine Kommentare

Tech-source Raptor Drivers for Linux Bedienungsanleitung Seite 27